Upgrade
Learn how to upgrade your Coder deployment to a newer version, with steps for each install method.
On this page
This article describes how to upgrade your Coder deployment.
Caution
Prior to upgrading a production Coder deployment, take a database snapshot since Coder does not support rollbacks.
For upgrade recommendations and troubleshooting, see Upgrading Best Practices.
Reinstall Coder to upgrade
To upgrade your Coder deployment, reinstall Coder using your original method of install.
Coder install script
-
If you installed Coder using the
install.shscript, re-run the below command on the host:curl -fsSL https://coder.com/install.sh | sh -
If you're running Coder as a system service, you can restart it with
systemctl:systemctl daemon-reload systemctl restart coder
Note
In Coder v2.34.0 and later, an option set to an empty value in /etc/coder.d/coder.env no longer keeps its default.
The deb, RPM, and apk packages for Coder v2.39 and earlier shipped a CODER_HTTP_ADDRESS= line with no value, and an upgrade keeps your existing file.
If the service fails to start with TLS is disabled. Enable with --tls-enable or specify a HTTP address, add a # at the start of that line, and then restart the service.
Other upgrade methods
If you installed using docker-compose, run the below command to upgrade the Coder container:
docker-compose pull coder && docker-compose up -d coder-
Run the Coder installation script on the host:
curl -fsSL https://coder.com/install.sh | shThe script will unpack the new
coderbinary version over the one currently installed. -
Restart the Coder system process with
systemctl:systemctl daemon-reload systemctl restart coder
Download the latest Windows installer or binary from the Coder downloads page, or upgrade from Winget.
winget install Coder.Coder